Maytag washer Sud code: too many suds

The washer detected too many suds and is adding extra rinses. Too much detergent or non-HE detergent is almost always the cause.

Likely causes

Listed from most to least common.

1. Non-HE detergent used
2. Too much detergent for the load size
3. No-splash or easy-pour liquid chlorine bleach
4. Detergent residue left in the washer
5. Drain hose kinked or clogged, slowing suds removal

How to fix the Sud code

1. 1

   Step 1: Let the cycle finish

   The washer pauses and adds water to break down the suds. The cycle takes longer, but this is normal.

2. 2

   Step 2: Switch to HE detergent

   Use only detergent with the HE logo. Measure it for the load size and follow the label.

3. 3

   Step 3: Change the bleach

   If you use no-splash or easy-pour liquid chlorine bleach, switch to regular liquid bleach.

4. 4

   Step 4: Run Clean Washer

   If the code still shows with the right detergent, run a Clean Washer cycle to remove built-up residue.

When to call a technician

No repair is usually needed. Call a technician only if Sud appears with HE detergent after a Clean Washer cycle and the drain hose is clear.

Models this applies to

• Front-load washers (MHW series, including Maxima)
• Top-load HE washers (MVW series, including Bravos)
• Older Centennial top-load washers with electronic controls

Codes can differ slightly between models. Your owner's manual is the final word and is available from Maytag support.

Common questions