Samsung washer Sud code: too many suds

The washer detected too much foam and paused to let it settle. It is caused by too much detergent or the wrong type.

Likely causes

Listed from most to least common.

1. Too much detergent for the load
2. Regular detergent used instead of HE detergent
3. Soft water, which needs less detergent
4. Clothes with leftover soap from hand washing

How to fix the Sud code

1. 1

   Step 1: Let the washer clear the suds

   This code is not a fault. The washer pauses and adds rinse steps on its own. Let it continue.

2. 2

   Step 2: Run an extra rinse

   If the cycle finishes with suds still visible, run a Rinse + Spin cycle with no detergent.

3. 3

   Step 3: Use less HE detergent next time

   Use only detergent marked HE and fill below the line in the drawer. Pods should go in the drum, not the drawer.

4. 4

   Step 4: Clean the machine

   Run the Self Clean or Pure Cycle with no clothes to remove built-up residue.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• HE laundry detergentCheck prices
• Washing machine cleaner tabletsCheck prices

When to call a technician

You do not need a technician for this code. If it appears even with very little detergent, run two Self Clean cycles to remove residue.

Models this applies to

• Front-load washers (WF series)
• Top-load washers (WA series)
• FlexWash and washer-dryer combos

Codes can differ slightly between models. Your owner's manual is the final word and is available from Samsung support.

Common questions