Maytag washer drn code: not draining properly

The top-load washer is not draining as it should. A kinked hose or a drain hose set up wrong at the standpipe is the most common cause.

Likely causes

Listed from most to least common.

1. Drain hose kinked or clogged
2. Drain hose more than 4.5 inches into the standpipe
3. Drain hose end too high or too low
4. House drain or utility sink pipe blocked
5. Drain pump blocked or failed

How to fix the drn code

1. 1

   Step 1: Check the drain hose

   Pull the washer out and straighten any kinks. Make sure nothing is pinching the hose against the wall.

2. 2

   Step 2: Set the hose depth

   Use the U-shaped hose form so only about 4.5 inches of hose is in the standpipe. Do not tape it in place.

3. 3

   Step 3: Check the house drain

   Pour a bucket of water into the standpipe or sink. If it backs up, the house drain is blocked.

4. 4

   Step 4: Clear and restart

   Press Start/Pause to clear the code, then run Drain and Spin.

You'll need: Bucket, towels, flashlight.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• Maytag washer drain pumpCheck prices

When to call a technician

If the hose and house drain are clear but water stays in the tub, the drain pump needs checking by a technician.

A typical repair for this code costs $150–$350 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Front-load washers (MHW series, including Maxima)
• Top-load HE washers (MVW series, including Bravos)
• Older Centennial top-load washers with electronic controls

Codes can differ slightly between models. Your owner's manual is the final word and is available from Maytag support.

Common questions