Maytag washer F7E1 code: motor speed error

The motor cannot reach the right speed for the cycle. Shipping bolts left in place or an overloaded drum are common causes on front-load models.

Likely causes

Listed from most to least common.

1. Shipping bolts or plastic spacers not removed after install
2. Drum overloaded or a heavy item restricting movement
3. Something caught between the drum and tub
4. Loose wiring between the motor and control
5. Faulty motor or motor control unit

How to fix the F7E1 code

Unplug the washer or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Check for shipping bolts

   On a new washer, check the back panel. All shipping bolts and their plastic spacers must be removed, as the installation instructions describe.

2. 2

   Step 2: Reduce the load

   Remove some items. With the washer off, turn the drum by hand to make sure it moves freely.

3. 3

   Step 3: Clear the code and reset

   Press Pause/Cancel twice, then Power. If the code returns, unplug the washer for 5 minutes and run Rinse and Spin with a small load.

You'll need: Flashlight, adjustable wrench.

When to call a technician

If the shipping bolts are out and the code returns with a light load, call a technician. Motor and control faults need electrical testing.

A typical repair for this code costs $200–$500 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Front-load washers (MHW series, including Maxima)
• Top-load HE washers (MVW series, including Bravos)
• Older Centennial top-load washers with electronic controls

Codes can differ slightly between models. Your owner's manual is the final word and is available from Maytag support.

Common questions