Haier washer UNB code: unbalanced load

The washer checks the load before spinning. If the laundry is bunched on one side, it spins slowly or not at all to avoid shaking, and shows UNB.

Likely causes

Listed from most to least common.

1. One heavy item, such as a rug, blanket or bath mat, washed on its own
2. Laundry tangled or bunched on one side
3. Very small load that cannot balance
4. Washer not level
5. Worn shock absorbers or suspension

How to fix the UNB code

1. 1

   Step 1: Spread the laundry out

   Open the door and spread the items evenly around the drum. Lay single large items, like a sheet, symmetrically.

2. 2

   Step 2: Wring out heavy items

   Squeeze excess water out of heavy, soaked items by hand before putting them back.

3. 3

   Step 3: Add a few items

   If washing one large item, add one or two towels to help balance it.

4. 4

   Step 4: Level the washer

   Check the washer with a level and adjust the feet so it sits flat and does not rock.

5. 5

   Step 5: Restart the spin

   Run Spin again. The washer should now reach full speed.

You'll need: Level, adjustable wrench.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• Haier washer shock absorbersCheck prices

When to call a technician

If normal mixed loads keep showing UNB and the washer is level, the shock absorbers or suspension may be worn.

A typical repair for this code costs $150–$350 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Front-load washers (HW series)
• Top-load washers (HWT and HWM series)
• Portable and compact washers

Codes can differ slightly between models. Your owner's manual is the final word and is available from Haier support.

Common questions