Haier washer FC2 code: communication error
- Urgency
- Medium
- Who can fix it
- Technician job
- Time
- About 10 min
- Repair cost
- $200–$450
The display board and the main power board have stopped communicating. A power reset sometimes clears it. If not, Haier advises contacting customer care.
Likely causes
Listed from most to least common.
- Brief power surge or interruption
- Loose wiring between the display and power boards
- Display board or power board failed
How to fix the FC2 code
Unplug the washer or switch it off at the breaker before removing any panel or filter.
Step 1: Reset the power
Unplug the washer, or switch off its circuit breaker, for 5 minutes. Plug it back in and start a short cycle.
Step 2: Plug into the wall directly
If the washer is on an extension cord or power strip, plug it straight into a wall socket.
Step 3: Book a repair
If FC2 returns, contact Haier service or a technician.
When to call a technician
A technician needs to check the wiring between the boards and replace whichever board has failed.
A typical repair for this code costs $200–$450 in the US, including parts and labor. Prices vary by area and model.
Models this applies to
- Front-load washers (HW series)
- Top-load washers (HWT and HWM series)
- Portable and compact washers
Codes can differ slightly between models. Your owner's manual is the final word and is available from Haier support.
Common questions
›Can a power cut cause FC2?
Yes. A surge or brief outage can cause it, and a power reset often clears it.
›Is FC2 expensive to fix?
It depends on the cause. A loose connector is cheap. A new control board costs more.