Haier washer FA code: water level sensor fault

The water level sensor has failed, so the washer cannot tell how much water is in the drum. Haier advises contacting customer care.

Likely causes

Listed from most to least common.

1. Water level (pressure) sensor failed
2. Sensor air tube blocked, kinked or disconnected
3. Wiring or control board fault

How to fix the FA code

Unplug the washer or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Unplug the washer

   Unplug it and close the water tap.

2. 2

   Step 2: Reset

   Leave it unplugged for 5 minutes, then plug in and run a short cycle. A one-off glitch may clear.

3. 3

   Step 3: Book a repair

   If FA returns, stop using the washer and contact Haier service or a technician.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• Haier washer water level sensorCheck prices

When to call a technician

The sensor or its air tube needs checking inside the washer. Book a technician.

A typical repair for this code costs $150–$300 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Front-load washers (HW series)
• Top-load washers (HWT and HWM series)
• Portable and compact washers

Codes can differ slightly between models. Your owner's manual is the final word and is available from Haier support.

Common questions