Haier washer F2 code: water at critical level

The water in the drum reached a critical level. Close the water tap to prevent an overflow and contact customer care, as Haier advises.

Likely causes

Listed from most to least common.

1. Water inlet valve stuck open
2. Water level sensor faulty
3. Control board fault

How to fix the F2 code

Unplug the washer or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Unplug and close the tap

   Unplug the washer and turn off the water tap right away.

2. 2

   Step 2: Drain the water

   Drain the drum, for example by running Drain/Spin briefly once the tap is closed, or by lowering the drain hose into a bucket.

3. 3

   Step 3: Book a repair

   Keep the tap closed until a technician has checked the washer.

You'll need: Towels, bucket.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• Haier washer water inlet valveCheck prices

When to call a technician

The inlet valve or level sensor needs replacing. Keep the tap closed and book a technician.

A typical repair for this code costs $150–$350 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Front-load washers (HW series)
• Top-load washers (HWT and HWM series)
• Portable and compact washers

Codes can differ slightly between models. Your owner's manual is the final word and is available from Haier support.

Common questions