Haier washer Err8 code: too much water

The water in the drum went above the maximum level. Haier advises unplugging the washer, closing the water tap and calling for service, because a valve that will not shut off can flood the room.

Likely causes

Listed from most to least common.

1. Water inlet valve stuck open
2. Water level (pressure) sensor or its tube faulty or blocked
3. Control board fault

How to fix the Err8 code

Unplug the washer or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Unplug and turn off the water

   Unplug the washer and close the water tap right away so it cannot keep filling.

2. 2

   Step 2: Drain the drum

   Put towels and a pan in front of the washer, open the bottom cover and drain the water through the emergency hose.

3. 3

   Step 3: Watch for filling while off

   Briefly open the tap with the washer still unplugged. If water flows into the drum, the inlet valve is stuck open. Close the tap again.

You'll need: Towels, shallow pan.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• Haier washer water inlet valveCheck prices

When to call a technician

Keep the tap closed and book a technician. The inlet valve or water level sensor needs replacing.

A typical repair for this code costs $150–$350 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Front-load washers (HW series)
• Top-load washers (HWT and HWM series)
• Portable and compact washers

Codes can differ slightly between models. Your owner's manual is the final word and is available from Haier support.

Common questions