GE washer FE code: water at critical level

The water inside the washer reached a critical level. GE says to turn off the water and power to the washer and call for service.

Likely causes

Listed from most to least common.

1. Water inlet valve stuck open
2. Water level (pressure) sensor or its tube faulty
3. Control board fault

How to fix the FE code

Unplug the washer or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Turn off the water

   Close both water valves behind the washer right away so it cannot keep filling.

2. 2

   Step 2: Turn off the power

   Unplug the washer, or switch off its circuit breaker if the plug is hard to reach or near water.

3. 3

   Step 3: Protect the floor

   Lay towels around the washer and wipe up any water. Do not restart the washer.

You'll need: Towels.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• GE washer water inlet valveCheck prices

When to call a technician

Always. GE advises calling service for FE. Keep the water off until a technician has checked the inlet valve and level sensor.

A typical repair for this code costs $150–$350 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Top-load washers with a digital display (2015 and newer)
• Top-load washers with status lights only
• Front-load washers (GE and GE Profile)

Codes can differ slightly between models. Your owner's manual is the final word and is available from GE support.

Common questions