LG washer FE code: overfill error

The washer has too much water. Turn off the water supply straight away, as the machine may keep filling.

Likely causes

Listed from most to least common.

1. Water inlet valve stuck open
2. Faulty water level sensor
3. Blocked pressure hose to the level sensor
4. Control board fault

How to fix the FE code

Unplug the washer or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Turn off the taps and unplug

   Close both taps behind the washer, then unplug it.

2. 2

   Step 2: Drain the water

   Use the drain tube behind the bottom-left panel on front-loaders, or plug in and run Spin Only with the taps closed.

3. 3

   Step 3: Check the inlet valve

   With the washer unplugged, briefly open the taps. If water flows in with no power, the inlet valve is stuck open.

You'll need: Towels, bucket.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• LG washer water inlet valveCheck prices
• LG washer water level sensorCheck prices

When to call a technician

If the valve is not stuck, have a technician test the water level sensor and main board.

A typical repair for this code costs $150–$350 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Front-load washers (WM series)
• Top-load washers (WT series)
• WashTower and washer-dryer combos

Codes can differ slightly between models. Your owner's manual is the final word and is available from LG support.

Common questions