Samsung dishwasher LC code: leak detected

The leak sensor in the base of the dishwasher detected water. The dishwasher will run its drain pump to protect your floor.

Likely causes

Listed from most to least common.

1. Too many suds from hand dish soap or too much detergent
2. Leaking door seal
3. Loose hose connection
4. Dishes or a large pan blocking the door from sealing

How to fix the LC code

Unplug the dishwasher or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Turn off power and water

   Switch off the dishwasher at the breaker and close the supply valve under the sink.

2. 2

   Step 2: Remove the water from the base

   Take off the toe kick panel and soak up any water with towels.

3. 3

   Step 3: Let it dry fully

   Leave it off for 24 hours or use a fan so the leak sensor dries.

4. 4

   Step 4: Check the door seal and detergent

   Wipe the door gasket, check it is not torn, and use only dishwasher detergent.

5. 5

   Step 5: Run a test cycle

   Run a short cycle and check underneath with a flashlight for drips.

You'll need: Screwdriver, towels, flashlight.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• Samsung dishwasher door gasketCheck prices

When to call a technician

If LC returns after drying and you cannot find the leak, have a technician inspect the internal hoses and pump seals.

A typical repair for this code costs $150–$350 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• DW80 series dishwashers
• Bespoke and StormWash models

Codes can differ slightly between models. Your owner's manual is the final word and is available from Samsung support.

Common questions