GE oven F7 code: keypad or touch panel fault

The control thinks a key on the touch panel is stuck or shorted. GE says F7 usually points to a keypanel problem, and the keypanel often needs replacing.

Likely causes

Listed from most to least common.

1. A key pressed down or stuck
2. Moisture or cleaner seeped behind the touch panel
3. Heat damage to the keypanel from the cooktop or self-clean
4. Failed keypanel membrane
5. Loose ribbon cable between keypanel and control

How to fix the F7 code

Unplug the oven or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Reset power at the breaker

   Turn off the circuit breaker for the oven for one to two minutes, then turn it back on. Watch the display to see if F7 returns.

2. 2

   Step 2: Dry the control panel

   Wipe the panel with a dry cloth. Next time, spray cleaner onto the cloth, not onto the panel, so liquid cannot seep behind it.

3. 3

   Step 3: Check for stuck keys

   Press each key gently and make sure none feels stuck or stays down.

4. 4

   Step 4: Leave it off if it was wet

   If liquid got behind the panel, leave the breaker off for a few hours to let it dry before trying again.

You'll need: Soft dry cloth.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• GE range keypanelCheck prices

When to call a technician

Call a technician if F7 returns after a reset and a dry panel. The keypanel will likely need replacing, and the part must match your model number.

A typical repair for this code costs $150–$400 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• GE electric and gas ranges (JB, JGB, JS and JGS series)
• GE Profile and Café ranges (PB, PGB, PS, CES and CGS series)
• Single and double wall ovens (JTS, JTD, PTS and CTS series)

Codes can differ slightly between models. Your owner's manual is the final word and is available from GE support.

Common questions