LG oven F7 code: convection fan error

The oven cannot detect the convection fan turning, usually for over a minute. A failed fan motor, a blocked fan blade or loose fan wiring is the usual cause.

Likely causes

Listed from most to least common.

1. Convection fan motor failed
2. Fan blade blocked by foil or debris
3. Loose wiring to the fan motor
4. Control board fault

How to fix the F7 code

Unplug the oven or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Clear the code

   Press Clear/Off and try the original function again.

2. 2

   Step 2: Check the fan cover

   With the oven cold, look at the fan cover on the back wall. Remove any foil or pans pressed against it.

3. 3

   Step 3: Reset power at the breaker

   Switch off the breaker for the range for about 30 seconds, then switch it back on.

You'll need: Flashlight.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• LG oven convection fan motorCheck prices

When to call a technician

If F7 returns after a reset, have a technician test the convection fan motor and wiring.

A typical repair for this code costs $150–$350 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Electric and gas ranges (LRE, LRG, LSE, LSG series)
• InstaView and ProBake slide-in ranges
• Induction ranges (LSIL, LSIS series)
• Single and double wall ovens (WSEP, WDEP series)

Codes can differ slightly between models. Your owner's manual is the final word and is available from LG support.

Common questions