GE oven F8 code: electronic oven control fault

The electronic oven control has found a fault inside itself. GE says the control usually needs to be replaced. A power reset can clear a one-time glitch.

Likely causes

Listed from most to least common.

1. Brief power surge or glitch
2. Failed electronic oven control board
3. Loose wiring at the control
4. Heat damage to the control from a self-clean cycle

How to fix the F8 code

Unplug the oven or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Reset power at the breaker

   Turn off the circuit breaker for the oven for one to two minutes, then turn it back on. Watch the display to see if F8 returns.

2. 2

   Step 2: Check the oven works

   Run a short bake at 350°F. If the code does not return, keep an eye on it over the next few uses.

3. 3

   Step 3: Note your model number

   If F8 comes back, find the model and serial number label. On most GE ranges it is on the frame behind the drawer or door. You need it for a new control.

You'll need: Flashlight.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• GE oven control boardCheck prices

When to call a technician

Call a technician if F8 returns after a power reset. The control board sits behind live panels and must match your model number.

A typical repair for this code costs $250–$550 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• GE electric and gas ranges (JB, JGB, JS and JGS series)
• GE Profile and Café ranges (PB, PGB, PS, CES and CGS series)
• Single and double wall ovens (JTS, JTD, PTS and CTS series)

Codes can differ slightly between models. Your owner's manual is the final word and is available from GE support.

Common questions