Whirlpool washer F9E1 code: long drain

The washer took too long to drain. Clean the drain pump filter and check the drain hose for kinks or blockages.

Likely causes

Listed from most to least common.

1. Drain pump filter clogged
2. Drain hose kinked or blocked
3. Drain hose pushed too far into the standpipe
4. House drain partly blocked
5. Drain pump failed

How to fix the F9E1 code

Unplug the washer or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Unplug and prepare for water

   Unplug the washer and lay towels and a shallow pan in front of it.

2. 2

   Step 2: Open the access panel

   On front-load models, open the small panel at the bottom front. Drain the water through the small tube if your model has one.

3. 3

   Step 3: Clean the drain pump filter

   Turn the filter counterclockwise slowly, let the water run out, then clear any debris and refit it securely.

4. 4

   Step 4: Check the drain hose

   Remove kinks and make sure the hose is not more than about 8 inches into the standpipe.

5. 5

   Step 5: Run Drain and Spin

   Plug the washer in and run Drain and Spin to confirm it drains normally.

You'll need: Towels, shallow pan, flashlight.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• Whirlpool washer drain pumpCheck prices

When to call a technician

If the filter and hose are clear but the washer still drains slowly or not at all, the drain pump likely needs replacing.

A typical repair for this code costs $150–$350 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Duet and front-load washers (WFW series)
• Some top-load washers (WTW series)

Codes can differ slightly between models. Your owner's manual is the final word and is available from Whirlpool support.

Common questions