Whirlpool washer F8E1 code: long fill, no water detected

The washer did not detect enough water within the expected time. Check the taps, hoses and inlet screens first.

Likely causes

Listed from most to least common.

1. Water taps closed or partly closed
2. Inlet hoses kinked or frozen
3. Clogged inlet filter screens
4. Low water pressure
5. Faulty water inlet valve

How to fix the F8E1 code

Unplug the washer or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Open both taps

   Turn both water taps behind the washer fully on.

2. 2

   Step 2: Check the hoses

   Make sure neither inlet hose is bent, crushed or frozen.

3. 3

   Step 3: Clean the inlet screens

   Turn off the water, unplug the washer and remove both hoses at the back. Pull out the mesh screens, rinse them and refit.

4. 4

   Step 4: Restart the cycle

   Plug in and start a Rinse and Spin or quick cycle. Check that water enters the drum.

You'll need: Needle-nose pliers, towel.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• Whirlpool washer water inlet valveCheck prices
• Washer inlet hosesCheck prices

When to call a technician

If water pressure is fine and the screens are clean but the drum will not fill, the inlet valve or water level sensor needs testing.

A typical repair for this code costs $120–$280 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Duet and front-load washers (WFW series)
• Some top-load washers (WTW series)

Codes can differ slightly between models. Your owner's manual is the final word and is available from Whirlpool support.

Common questions