Whirlpool oven F8E0 code: cooling fan speed too low

The control detected that the cooling fan is running too slowly. Whirlpool lists blocked airflow, the oven cooling fan or its wiring. The fan keeps the controls cool, so the oven may stop heating.

Likely causes

Listed from most to least common.

1. Vents near the control panel or cooktop blocked
2. Cooling fan blades obstructed by grease or debris
3. Worn or failed cooling fan motor
4. Loose wiring to the fan

How to fix the F8E0 code

Unplug the oven or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Clear the vents

   Remove anything sitting on or against the oven vents, including pans on a rear vent and items stacked at the back of the cooktop.

2. 2

   Step 2: Reset power at the breaker

   Turn off the circuit breaker for the oven for one minute, then turn it back on. Watch the display for one minute.

3. 3

   Step 3: Listen for the fan

   Bake at 350°F for a few minutes. You should hear the cooling fan running. Grinding, rattling or silence points to the fan.

You'll need: Flashlight.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• Whirlpool oven cooling fanCheck prices

When to call a technician

Call a technician if the fan is noisy or silent after a reset. The fan sits behind the back or top panel, and the wiring must be checked with power off.

A typical repair for this code costs $150–$350 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Electric and gas freestanding ranges (WFE, WFG and WEE series)
• Slide-in ranges (WEE, WEG and WEC series)
• Single, double and combination wall ovens (WOS, WOD and WOC series)

Codes can differ slightly between models. Your owner's manual is the final word and is available from Whirlpool support.

Common questions