Skip to content
FixCodes

Whirlpool oven F2E0 code: keypad or touch panel fault

Urgency
Medium
Who can fix it
Moderate DIY
Time
About 20 min
Repair cost
$150–$450

The control has found a problem with the keypad or touch panel. Whirlpool lists the keypad, the control or the wiring between them. Moisture or a stuck key are common triggers.

Likely causes

Listed from most to least common.

  1. A key stuck down or pressed for too long
  2. Moisture or cleaner seeped behind the touch panel
  3. Failed keypad or touch panel
  4. Loose ribbon cable between keypad and control
  5. Faulty oven control board

How to fix the F2E0 code

Unplug the oven or switch it off at the breaker before removing any panel or filter.

  1. Step 1: Reset power at the breaker

    Turn off the circuit breaker for the oven for one minute, then turn it back on. Watch the display for one minute.

  2. Step 2: Dry the control panel

    Wipe the panel with a dry cloth. Next time, spray cleaner onto the cloth, not onto the panel, so liquid cannot seep behind it.

  3. Step 3: Check for stuck keys

    Press each key gently and make sure none feels stuck or stays down.

  4. Step 4: Leave it off if it was wet

    If liquid got behind the panel, leave the breaker off for a few hours to let it dry before trying again.

You'll need: Soft dry cloth.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

When to call a technician

Call a technician if the code returns after a reset and a dry panel. The keypad or control board will need replacing, and the part must match your model number.

A typical repair for this code costs $150–$450 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

  • Electric and gas freestanding ranges (WFE, WFG and WEE series)
  • Slide-in ranges (WEE, WEG and WEC series)
  • Single, double and combination wall ovens (WOS, WOD and WOC series)

Codes can differ slightly between models. Your owner's manual is the final word and is available from Whirlpool support.

Common questions

›Why does my Whirlpool oven beep and show F2E0?

The control thinks a key is stuck or shorted. It beeps and shows the code to stop the oven acting on false key presses.

›Can I replace a Whirlpool oven keypad myself?

On many models, yes, if you are handy and the breaker is off. The keypad is often bonded to the panel, so the whole console part may be needed.

Did this fix work?

All Whirlpool oven codes