Whirlpool oven F5E0 code: door latch or door switch fault

The control did not get the expected signal from the door latch or door switch. Whirlpool lists the latch assembly, the door switch or their wiring. It often shows up during or after self-clean.

Likely causes

Listed from most to least common.

1. Oven door not fully closed
2. Food or debris blocking the latch
3. Failed door latch motor or latch switch
4. Faulty door switch
5. Loose wiring at the latch

How to fix the F5E0 code

Unplug the oven or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Check the door

   Make sure the door closes fully and nothing is caught in the gasket or near the latch opening.

2. 2

   Step 2: Reset power at the breaker

   Turn off the circuit breaker for the oven for one minute, then turn it back on. Watch the display for one minute.

3. 3

   Step 3: Let a hot oven cool

   If the code appeared during self-clean, leave the oven to cool fully. Never force a locked door open.

You'll need: Flashlight.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• Whirlpool oven door latch assemblyCheck prices
• Whirlpool oven door switchCheck prices

When to call a technician

Call a technician if the door stays locked when the oven is cool or the code keeps returning. Do not try to bypass the door lock.

A typical repair for this code costs $150–$350 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Electric and gas freestanding ranges (WFE, WFG and WEE series)
• Slide-in ranges (WEE, WEG and WEC series)
• Single, double and combination wall ovens (WOS, WOD and WOC series)

Codes can differ slightly between models. Your owner's manual is the final word and is available from Whirlpool support.

Common questions