LG dishwasher FE code: too much water (overfill)

The dishwasher has detected too much water in the tub. Check for suds, level the unit and load large items upside down, then retry.

Likely causes

Listed from most to least common.

1. Too many suds from dish soap or too much detergent
2. Dishwasher not level or door out of line
3. Large items catching and holding water
4. Water inlet valve not shutting off

How to fix the FE code

Unplug the dishwasher or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Turn off power and water

   Switch off at the breaker and close the supply valve under the sink if water is escaping.

2. 2

   Step 2: Check for suds

   Use only dishwasher detergent, never hand dish soap. Clear any suds before the next cycle.

3. 3

   Step 3: Check the level

   Place a level on the tub opening and adjust the feet so the unit sits level.

4. 4

   Step 4: Reload and retry

   Load large plates and pots upside down, restore power and water, then run a cycle.

You'll need: Level, adjustable wrench, towels.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• LG dishwasher water inlet valveCheck prices

When to call a technician

If FE returns with no suds and a level unit, the inlet valve may be stuck open. Have a technician check it.

A typical repair for this code costs $120–$300 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• LDF, LDT and LDP series
• QuadWash and TrueSteam models

Codes can differ slightly between models. Your owner's manual is the final word and is available from LG support.

Common questions