Frigidaire dishwasher iC0 code: electronic control problem
Also shown as EC0
- Urgency
- Medium
- Who can fix it
- Technician job
- Time
- About 10 min
- Repair cost
- $200–$450
The dishwasher found a fault in its electronic control system. Cut power for 5 minutes to reset it. If it returns, a board needs service.
Likely causes
Listed from most to least common.
- Temporary glitch after a power surge
- Loose cable between the control panel and main board
- Moisture in the control panel
- Faulty user interface board
- Faulty main control board
How to fix the iC0 code
Unplug the dishwasher or switch it off at the breaker before removing any panel or filter.
Step 1: Reset the power
Switch the dishwasher off at the breaker for 5 minutes, then turn it back on.
Step 2: Try a cycle
Start a quick cycle and see whether the code comes back.
Step 3: Let the panel dry
If steam or water reached the controls, leave the door open with power off for a few hours.
Parts that may need replacing
Check your model number on the label inside the door or on the back before ordering.
- Frigidaire dishwasher main control boardCheck prices
When to call a technician
If iC0 returns after a power reset, call a technician to check the wiring and control boards.
A typical repair for this code costs $200–$450 in the US, including parts and labor. Prices vary by area and model.
Models this applies to
- Gallery dishwashers (FGID series)
- Professional dishwashers (FPID series)
Codes can differ slightly between models. Your owner's manual is the final word and is available from Frigidaire support.
Common questions
›Does iC0 mean I need a new control board?
Not always. A power reset often clears it. A loose cable between the boards can also cause it.
›Can a power outage cause iC0?
Yes. A surge or brief outage can confuse the controls. Cut power for 5 minutes to reset them.