Skip to content
FixCodes

LG refrigerator Er gF code: water flow sensor error

Also shown as gF

Urgency
Low
Who can fix it
Easy DIY
Time
About 15 min
Repair cost
$150–$300

The water flow sensor is reading no flow or the wrong flow. It is usually a closed supply valve, a kinked water line or water pressure outside LG's range, rather than a failed part.

Likely causes

Listed from most to least common.

  1. Water supply valve closed or only partly open
  2. Water line kinked behind the fridge
  3. Water pressure too low or too high
  4. Clogged water filter
  5. Flow sensor failed

How to fix the Er gF code

Unplug the refrigerator or switch it off at the breaker before removing any panel or filter.

  1. Step 1: Reset the refrigerator

    Unplug the refrigerator for 60 seconds and plug it into a wall outlet, not a power strip. Allow up to 5 minutes for it to restart.

  2. Step 2: Open the water supply

    Make sure the shutoff valve feeding the fridge is fully open and the water line is not kinked when you push the fridge back.

  3. Step 3: Check the water pressure

    LG fridges need 20 to 120 psi, or 40 to 120 psi on models with a water filter. If the ice tray overfills, partly close the supply valve to lower the pressure.

  4. Step 4: Replace an old filter

    If the water filter is more than 6 months old, replace it, as a clogged filter cuts flow.

You'll need: Flashlight.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

When to call a technician

If the valve is open, the line is clear and pressure is in range but gF still shows, the flow sensor or inlet valve needs service.

A typical repair for this code costs $150–$300 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

  • French door refrigerators (LF, LR and LM series)
  • Side-by-side refrigerators (LS and LRS series)
  • InstaView Door-in-Door models
  • Linear and inverter linear compressor models

Codes can differ slightly between models. Your owner's manual is the final word and is available from LG support.

Common questions

›Can a new water filter cause a gF code?

It can if the filter is not seated fully or has trapped air. Reseat the filter and dispense a few glasses of water to purge the air.

›Why is my ice maker overfilling with a gF code?

Water pressure may be too high, or the flow sensor may be misreading. Partly close the supply valve and see if it improves.

Did this fix work?

All LG refrigerator codes