KitchenAid dishwasher F7E2 code: wash motor error

The control found a problem with the wash motor, which pumps water through the spray arms. A reset can clear it, but repeat codes need service.

Likely causes

Listed from most to least common.

1. Failed wash (circulation) motor
2. Debris jamming the wash pump
3. Loose wiring to the motor
4. Main control fault

How to fix the F7E2 code

Unplug the dishwasher or switch it off at the breaker before removing any panel or filter.

1. 1

   Step 1: Clean the filter

   Remove the bottom rack and filter. Rinse the filter and look for glass or other debris in the sump.

2. 2

   Step 2: Reset the control

   Unplug the dishwasher or switch off its breaker for 30 seconds, then restore power and run a short cycle.

You'll need: Soft brush, gloves.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• KitchenAid dishwasher circulation pump motorCheck prices

When to call a technician

If F7E2 comes back after a reset, schedule service. Replacing the wash motor means pulling the dishwasher out and working on power and water connections.

A typical repair for this code costs $250–$550 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• Top-control dishwashers (KDTE, KDTM and KDPM series)
• Front-control dishwashers (KDFE series)
• Models without a display that flash the Clean light

Codes can differ slightly between models. Your owner's manual is the final word and is available from KitchenAid support.

Common questions