GE dishwasher C2 code: total drain time over 7 minutes

The drain pump ran for more than 7 minutes in total during the cycle. This points to a slow or partly blocked drain, the same as C1.

Likely causes

Listed from most to least common.

1. Partly blocked air gap or drain hose
2. Garbage disposal or sink drain clogged
3. Filter or sump full of food
4. Weak or failing drain pump

How to fix the C2 code

1. 1

   Step 1: Stop the beeping

   Press Start/Reset to silence the alert.

2. 2

   Step 2: Clear the sink drain

   Run the garbage disposal and check that the kitchen sink drains quickly.

3. 3

   Step 3: Check the air gap and hose

   Clean out the air gap cap by the faucet and straighten any kinks in the drain hose under the sink.

4. 4

   Step 4: Clean the filter

   Remove the bottom rack, take out the filter and rinse it. Scoop out any standing water first.

You'll need: Flashlight, sponge and cup, soft brush.

Parts that may need replacing

Check your model number on the label inside the door or on the back before ordering.

• GE dishwasher drain pumpCheck prices

When to call a technician

If the drain path is clear and C2 returns, the drain pump may be weak. A technician can test and replace it.

A typical repair for this code costs $120–$300 in the US, including parts and labor. Prices vary by area and model.

Models this applies to

• GE built-in dishwashers (GDT, GDF, GDP series)
• GE Profile dishwashers (PDT series)
• Café dishwashers (CDT series)

Codes can differ slightly between models. Your owner's manual is the final word and is available from GE support.

Common questions